Display Assembly - HP EliteBook 835 G8 Maintenance And Service Manual

6. Lift the side of the system board upward (1), and then pull the system board away from the connectors
on the side of the computer to remove it (2).
Reverse this procedure to install the system board.

Display assembly

To remove and disassemble the display assembly, use these procedures and illustrations.
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Before removing the display panel, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Disconnect the battery cable from the system board (see
4. Remove the power connector cable (see
Remove the display assembly:
1. Disconnect the display cable (1) and the antenna cables from the WWAN module (2), and then remove
the cables from the clip (3).
58 Chapter 6 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page 32).
Power connector cable on page
32).
Battery on page 42).
47).