Touchpad - HP EliteBook 835 G8 Maintenance And Service Manual

3. Remove the fingerprint reader board from the computer (4).
Reverse this procedure to install the fingerprint reader board.

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 6-8 Touchpad description and part number
Description
Touchpad
Touchpad with NFC antenna
Touchpad cable (included in Cable Kit)
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
Remove the touchpad:
1. Disconnect the cable from the ZIF connector on the touchpad (1).
2. Lift the tape from the touchpad (2).
3. Disconnect the cable from the reverse ZIF connector on the NFC module (3).
4. Remove the six Phillips M1.6 × 1.8 screws (4) that secure the touchpad to the computer.
50 Chapter 6 Removal and replacement procedures for authorized service provider parts
Preparation for disassembly on page
Bottom cover on page
Battery on page 42).
32).
Spare part number
M36399-001
M36400-001
M08526-001
32).