Bedding Attachment Assembly (Option) - Landoll 1550 Series Operator's Manual

Bedding Attachment Assembly
(Option)
1. Attach bracket weldment, option bar to the frame
using center shank mount u-bolts and 5/8-11 hex
lock nuts (See Figures 3-7 and 3-8.)
2. Attach square tube to other end of bracket weldment,
option bar using rigid gauge wheel u-bolts and 5/8-11
hex lock nuts.
3. Connect bedding shank bracket weldment to tube
centered between shanks using bedding clamp plate
and 1-8 hex lock nuts.
m1550-bedding-3
Figure 3-8: Bedding Attachment Assembly
ASSEMBLY INSTRUCTIONS
4. Slide bedding attachment shank into bedding shank
bracket weldment. Hold in place with 7/8-9 x 3-1/4
hex head cap screws and hex lock nuts.
5. Slide shank foot piece onto lower end of bedding
attachment shank. Attach through lower holes with
1/2-13 x 2-3/4 hex head cap screw and hex lock nut.
Through the top hole of shank and slot of shank foot
piece, attach with 5/8-11 x 3 hex head cap screw, flat
washers, and hex lock nut and adjust to needed
angle.
6. Slide lister bottom over end of shank foot piece and
connect with 3/4-10 x 5 round head square neck
screw, flat washer, split lock washer, and hex nut.
3-13