Prepare The Temperature Station; Insert The Battery; Set The Transmitter Id - DAVIS Wireless Temperature Station Installation Manual

Preparing the Temperature Station
The illustration below shows the Sensor Interface Module, or "SIM",
inside the shelter.
Insert the 3-volt lithium battery into the battery holder, matching the "+"
sign on the battery with the "+" sign on the SIM.
Note: Note the location of the DIP switches. You will work with them during the next installation step.
The Temperature Probe Cable is installed and mounted with the cable clamp at the factory.
Setting the Transmitter ID
Each wireless transmitting station must be set to one of eight transmitter
IDs. DIP switches #1, 2 and 3 on the SIM allow you to control the ID —
the "channel" the station transmits on. (DIP switch #4 is used for transmis-
sion testing, not for transmitter ID.)
-
+
UV UV SUN SUN RAIN RAIN
Square Black Grommets
Sensor Interface Module on Wireless Temperature Station
3-Volt
Lithium Battery
DIP Switches
Test LED
SENSOR SENSOR
INTERFACE INTERFACE
MODULE MODULE
TEMP TEMP
WIND WIND
HUM HUM
Cable Clamp
Screw
Cable Clamp
Cable Clamp
Mount
Temperature Probe
Cable
3