Prepare The Temperature Station; Insert The Battery; Set The Transmitter Id; Setting The Transmitter Id - DAVIS 6372 Installation Manual

Preparing the Temperature Station
The illustration below shows the Sensor Interface Module, or "SIM",
inside the shelter.
Insert the 3-volt lithium battery into the battery holder, matching the "+"
sign on the battery with the "+" sign on the SIM.
Note: Note the location of the DIP switches. You will work with them during the next installation step.
The Temperature Probe Cable is installed and mounted with the cable clamp at the factory.

Setting the Transmitter ID

Each wireless transmitting station must be set to one of eight transmitter
IDs. DIP switches #1, 2 and 3 on the SIM allow you to control the ID —
the "channel" the station transmits on. (DIP switch #4 is used for
transmission testing, not for transmitter ID.)
UV UV
Square Black Grommets
Sensor Interface Module on Wireless Temperature Station
3-Volt
Lithium Battery
-
+
SENSOR SENSOR
INTERFACE INTERFACE
MODULE MODULE
TEMP TEMP
RAIN RAIN WIND WIND
SUN SUN
HUM HUM
Test LED
DIP Switches
Cable Clamp
Screw
Cable Clamp
Cable Clamp
Mount
Temperature Probe
Cable
3