Using Instructions - Heinner SM-2H700WH Instruction Manual

www.heinner.com
V.

USING INSTRUCTIONS

BEFORE FIRST USE
Read all instructions carefully and keep them for future reference.
• Remove all packaging
• Clean the Cooking Plates by wiping a sponge or cloth dampened in warm water.
DO NOT IMMERSE THE UNIT AND DO NOT RUN WATER DIRECTLY ON THE COOKING
SURFACES.
• Dry with a cloth or paper towel.
• For best results, lightly coat the cooking plates with a little cooking oil or cooking
spray.
Notice: When your Grill Toaster is heated for the first time, it may emit slight smoke or
odor. This is normal with many heating appliances. This does not affect the safety of
your appliance.
HOW TO USE
• Close the Grill Toaster and plug it into the wall outlet, you will notice that the power
and the ready light will go on, indicating that the Grill Toaster has begun preheating.
• It will take approximately 5 minutes to reach baking temperature, the ready light will
goes off.
• Open the lid, put the sandwich, meat or other foods on the bottom cooking plate.
• Close the lid. The ready light will go on again.
• Cook for about 3 to 6 minutes, the ready light goes off again, or until golden brown,
adjusting the time to suit your own individual taste.
• When the foods is cooked use the handle to open the lid. Remove the food with the
help of a plastic spatula. Never use metal tongs or a knife as these can cause damage
to the non-stick coating of the cook plates.
• Once you are finished cooking, disconnect the plug from the wall outlet and leave unit
open to cool.
TO REMOVE COOKING PLATES
• Always unplug the Grill Toaster and allow it to cool
before removing cooking plates.
• Open the Grill Toaster, locate the plate release buttons
on front of the unit. Press firmly on button and the plate
will pop up slightly from the base. Grasp the plate with
two hands, slide it out from under the metal brackets,
and lift it out of the bas. Press on the other plate release
button to remove the other cooking plate in the sane
manner.
700W, 220-240V, ~ 50/60Hz
Release button
Release button
4