Huawei Telecom Power TP48200A-HT19C3 User Manual page 67

Table of Contents

TP48200A-HT19C3 and TP48200A-HT19C4 Telecom

Power

User Manual

Step 5 Remove the circuit breaker from the guide rail. Figure 4-6 shows how to remove the circuit

breaker.

Figure 4-6 Removing the circuit breaker

Step 6 Switch off the new circuit breaker. Press the buckle at the circuit breaker base using an

insulated flat-head screwdriver and install the new circuit breaker. Then remove the

screwdriver so that the buckle secures the circuit breaker to the guide rail.

Step 7 Tighten the screw that secures the lower port of the circuit breaker.

Step 8 Remove the insulation tape from the output power cable and signal cable terminals. Then

connect the output power cable and signal cable terminals to the upper port of the circuit

breaker and tighten the screw.

Step 9 Switch on the circuit breaker. Figure 4-7 shows how to install the new circuit breaker.

Figure 4-7 Installing the new circuit breaker

----End

Follow-up Procedure

Check that the load fuse blown alarm has disappeared.

Issue 03 (2019-11-15)

4 Maintenance

Table of Contents

Need help?

Do you have a question about the Telecom Power TP48200A-HT19C3 and is the answer not in the manual?

Telecom power tp48200a-ht19c4Tp48200a-ht19c3Tp48200a-ht19c4