Back-Function; Status Display; Passive Display Mode - Webasto SmartControl Operating Instructions Manual

3.3.1

Back-function

Exit the selected menu with the "Back" function.
The settings are saved and the higher-level menu level is displayed.
Back
3.4

Status display

Status of the heater is indicated by means of the colour backlight of the quick start
button.
Status
Heating mode
Ventilation mode
Switched off heater - control element is activated
Error - no heating mode, see chapter „11 Error mes-
sage" on page 29.
Preprogrammed heating mode - control element in
stand-by mode
Preprogrammed ventilation mode - control element in
stand-by mode
If a user does not make any entry by means of the control element for 60
seconds and the heater is switched off then the control element will go into
the stand-by mode (display and LED are switched off).
3.5

Passive display mode

If the heater is activated by another Webasto control element (e.g. Telestart or Thermo-
call), the control element wakes up from sleep mode and the operation mode selected
by the other control element is shown on the display. Displayed information depends on
the connected heater.
Display Operating mode
Heating
X
The passive mode can be deactivated by pressing quick start button
X
. The heater is switched off.
LED backlight
GREEN permanent
BLUE permanent
WHITE permanent
RED flashing
GREEN flashing
BLUE flashing
9