Setting The Remaining Operation Time Of Fan During Ventilation Mode; Switching Off; Programming The Timer Menu (Time Setting) - Webasto SmartControl Operating Instructions Manual

Turn the control knob in order to choose fan speed.
X X
Press the control knob within 5 seconds in order to confirm
X X
selection.
6.3 Setting the remaining operation time of fan during ventila-
tion mode
3
The heater is in the ventilating mode
Turn the control knob in order to adjust the desired remain-
X X
ing operation time.
By means of turning the control knob in anticlockwise direction
one can shorten remaining operation time.
If longer remaining operation time is desired then longer remai-
ning operation time must be reset.
Press the control knob within 5 seconds in order to confirm
X X
selection.
7

Switching off

3
Heater in operation
Press quick start button.
X X
Backlight of quick start button changes its colour from blue (in ventilation
mode) or green into white colour (in heating mode).
8

Programming the Timer menu (time setting)

This function is available only for control element of MultiControl.
There is a possibility of programming the time settings 7 days in advance. The heater
switches on automatically at the programmed time. There is a possibility of saving up to
3 time settings per day and altogether up to 21 time settings.
Depending on the used variant of MultiControl device and application case (e.g. in a car,
in a truck, on the boat, etc.), the number of actively available timers can fluctuate. There
are maximum 21 active timers available.
The desired temperature or fan speed should be set in accordance with the desired
operating mode ("heating" or "ventilation").
16