Performing Reset; 10 Cleaning; 11 Error Message; Error Codes - Webasto SmartControl Operating Instructions Manual

9.13

Performing reset

As for reset option, all settings are restored to factory settings (standard settings are
configured by a service technician) except a day of a week and an hour.
3
The menu element "Settings" has been chosen.
Turn the control knob in order to choose menu element
X X
"Reset".
Press the control knob in order to confirm selection.
X X
"OK" is shown in the display.
Press the control knob in order to confirm selection.
X X
Then the restart is performed.
Personal settings are deleted. This procedure cannot
be cancelled.

10 Cleaning

In order to clean the control element, you should use only a soft lint-free cloth. No moi-
sture can enter the housing. You cannot use window pane cleaning agents, household
cleaners, sprays, solvents, cleaning agents contining alcohol and scouring agents for
cleaning.

11 Error message

Error messages regarding the heater will be displayed with the "F" or "H" marking and
can be found in the appropriate description of the heater. Error messages regarding the
control element are displayed by means of „T" symbol.
3
Error message is shown in the display.
Press the control knob in order to confirm error message.
X X
■
■
11.1

Error codes

If error message appears in the display, please contact the technical support/ custo-
X X
mer service.
ATTENTION
Inspections and repairs on heaters must only be carried out by trained
personnel.
Error message is stored in error memory.
If not confirmed, the error message is displayed
again (e.g. on restart or when waking up from
sleep mode).
Settings
Reset
Settings
Reset
29