Pro-Cut X9 Technical Manual page 67

GYR TROUBLESHOOTING GUIDE
LATHE/PC will not communicate. Screen lower left reads "Disconnected." Motor does turn on.
ISSUE
TROUBLESHOOT
1. CHECK ALL WIRING CONNECTIONS. After making sure all are connected, cycle
the AC power to the lathe by unplugging it from the wall and plugging it in again.
2. At the lathe computer box, unplug the USB cable, wait a few seconds and then
re-seat the USB cable.
Lathe will not run; computer is on.
ISSUE
TROUBLESHOOT 1. Check power cord connections.
2. Check shut-off cam.
ISSUE Scanner will not respond
TROUBLESHOOT 1. Check the scanner's USB cable connections.
2. Clean vehicle's barcode / windshield.
3. Vary barcode scanner distance.
4. Approach barcode with scanner at a 30-degree angle.
WWW.PROCUTUSA.COM PG / 67