Pro-Cut X9 Technical Manual page 32

50-1650 SLIDE PLATE
Slide Plate Resistance Adjustment
1. Remove the Cutting Head from the Slide Plate.
2. Center the Slide Plate on the Gear Box between the screws that are through the
dove tail plate.
3. Locate and loosen the 2 wedge locating screws on the slide plate.
4. Be sure that the runners of the slide plate are clean and free of debris.
5. Grasping the slide plate on the side opposite of the slide rail, wiggle it back and
forth at the same time push on the side where the rail is located.
4. Tighten the 2 wedge locating screws.
4. Test the resistance of the slide plate by turning the clutch knob. There should not
be any sideward movement or looseness in the slide plate.
PG / 800.543.6618
32
RESISTANCE ADJUSTMENT AND FEED SCREW ADJUSTMENT
3
2
Detail of the 50-1650 Slide Plate