Table of Contents
Advertisement
3. SOLID RED
If the light on the
Signal Booster
is solid red, this
indicates that the
Signal Booster
has shut down
on that frequency
to prevent an oscillation (feedback) . First, make sure that all the
connections are tight . Then reduce the gain of the booster in small
increments by rotating the appropriate gain control knob counter
clockwise, waiting 5 seconds between each adjustment for the
booster to reset . Continue this adjustment until the light turns
blinking or solid green . When you are turning down the gain, you
are reducing the coverage
area . If the amount of coverage
area is sufficient for your
needs and the light is green,
the installation is complete .
If the coverage area is not
large enough, it is necessary
to increase the separation
distance of the Inside and
Outside Antennas by moving
them horizontally or vertically
farther apart . Then increase the
gain until the red light comes on, and then slightly decrease the gain
until the green or blinking green light appears . If after separating
the antennas your coverage area is still too small, contact Wilson
Electronics Technical Support Team for assistance: 866-294-1660 .
If your installation takes longer than 15 minutes, it is possible to re-
enter the installation mode by disconnecting and reconnecting the
power supply from the Signal Booster .
4. SOLID GREEN
The indicator light on the Signal Booster will be a solid green after
the first 15 minute installation period, if the unit is powered up and
working properly .
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
Figure 8
Red
Min
800
MHz
Max
SMART
TECHNOLOGY
™
800
MHz
CH
Select
Mon.- Fri. Hours: 7 am to 6 pm MST.
Min
Max
UL CH DL
70 A 72
Move farther apart to
increase coverage
(horizontally or vertically)
Red
1900
MHz
Dual Band
Channelized
Signal Booster
1900
MHz
CH
Select
14
Advertisement
Table of Contents
