Wilson Electronics 277280 Installation Manual page 7

Dual-band channelized 800/1900 mhz in-building wireless smart technology ii
Table of Contents

Advertisement

the antenna is not pointing across your own roof or at the Inside Antenna
as this will cause the oscillation protection circuitry to shut down the
Signal Booster .
Warning:
Lightning protection is recommended for all installations
(#859902-50 Ohm shown below) . Take extreme care to ensure
that neither you nor the antenna comes near any electric power lines .
Installing Lightning Protection
Install the Lightning Surge
Protector (LSP) close to the Signal
Booster . Attach the cable from
the Outside Antenna to the surge
protector, using a short length of
low loss cable; attach one end
to the LSP and the other to the
Outside Antenna connector on the
Signal Booster . Ensure the LSP is
properly grounded (ground wire not
included) . LSP sold separately, go
to www.WilsonElectronics.com or
call 800-204-4104 to order .
Selecting a Direction for the Outside Antenna
Before selecting a location on the roof of the building to install the
Outside Antenna, see page 7 for additional instructions . Use a cell phone
in test mode to find the strongest signal from the cell tower (refer to page
5 for more information) . To get the strongest signal possible, it is very
important to set up your Outside Antenna properly . The Inside and the
Outside Antenna must be mounted in such a way that they are able to
pick up the best possible cell signal on the outside of the building and
provide the best possible signal on the inside of the building . Mount the
Outside Antenna as high as possible facing the cell tower in an area with
the best possible signal coverage .
Note: Never point the front of a directional antenna toward the Inside
Antenna. See Figures 1 & 2 on page 10.
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com.
(sold separately)
Lightning
Surge Protector
(sold separately)
(not included)
To Inside
Antenna
Signal Booster
Surge Protector Power Strip
Mon.- Fri. Hours: 7 am to 6 pm MST.
To Outside
Antenna
Ground Wire
(not included)
To Signal
Booster
6

Advertisement

Table of Contents
loading

Table of Contents