Warnings And Recommendations - Wilson Electronics SIGNALBOOST MINI-AMP Installation Manual

Warnings and Recommendations

Warning:
Warning:
Warning:
Warning:
Separation of inside and outside antennas is very important. The metal
roof of the vehicle acts as a barrier and helps shield the two antennas from
each other, preventing oscillation.
If the vehicle has a sunroof, it is important to separate the inside and outside antennas
by at least fi ve feet. This prevents the amplifi er from overloading or oscillating.
9
Amplifier Instructions - SBoostMSec1:9 Sec1:9 Amplifier Instructions - SBoostMSec1:9 Sec1:9
In a wireless installation, do not plug the amplifi er directly into
the cell phone or cellular data card using an antenna adapter. It
will damage the cell phone or cellular data card.
Do not plug in the DC power supply until the outside and inside
antenna cables are attached to the amplifi er.
RF Safety: The inside antenna must be installed with a
separation of at least eight inches from all persons and must not
be located in conjunction with any other antenna or amplifi er.
RF Safety: The outside antenna must be installed with a
separation of at least 10 inches from any of the vehicle's
occupants or nearby persons and must not be located or
operating in conjunction with any other antenna or amplifi er. All
roof-mount antennas should be centrally located on the roof of
the vehicle. Use of this cellular amplifi er with an antenna gain
higher than 6.12 dBi is in violation of FCC regulations for which
the offender is fully liable. All Wilson mobile antennas are 6.12
dBi or less.
Distance between antennas
through a sunroof must be
5 feet or more.
4/2/2008 9:16:59 AM 4/2/2008 9:16:59 AM