Table of Contents
Advertisement
TILTING THE TABLE
1. Loosen the nut below the table. Fig. 24.
2. Tilt table to desired angle.
3. A Tilt scale and pointer are provided on the
bracket to indicate the angle.
4. Tighten nut.
CHANGING SPINDLE SPEEDS
1. Turn off and disconnect the power to the Drill
Press.
2. Open belt cover.
3. Release the tension on the belt by loosening
the belt tension lock (A-Fig.25) and pull
forward on the motor (B-Fig. 25).
4. Choose the desired speed by referring to the
speed selection chart.
5. Place the belt on the pulleys in relation to the
speed chosen on the speed selection chart
starting with the motor pulley first. Fig. 26.
6. Push back on the motor until there is approx-
imately 1/2" deflection in the belt. Fig. 27.
7. Tighten the belt tension lock handle.
8. Close the belt guard.
9. Reconnect the Drill Press to the power.
ADJUSTMENTS
Figure 27
BE PLUGGED IN AND THE POWER SWITCH
MUST BE IN THE OFF POSITION UNTIL ALL
ADJUSTMENTS, MAINTENANCE OR ANY
NECESSARY REPAIRS ARE COMPLETE.
A
14
Figure 24
THE MACHINE MUST NOT
B
Figure 25
Figure 26
Advertisement
Table of Contents
