Table of Contents
Advertisement
INSTALLING THE TABLE
1. Install the arm onto the table support with hex
bolt (A-Fig.15) and make sure the scale is on
zero position (B-Fig.15). If necessary, adjust
the hex socket screw (C-Fig.16) to lever the
table 90 degree to the spindle.
B
2. Insert the table post (A-Fig.16) into the table
support bracket (B-Fig.16) as shown.
3. Tighten the locking lever (A-Fig.17) onto the
table support bracket (B-Fig.17) and install the
table raising/lowering handle (C-Fig.17).
HEAD ADJUSTMENTS
Tilting the Drill Press Head 45
90
Counterclockwise
o
1. Loosen the lock handle (A-Fig.18) on the right
side of the drill press head.
2. Pull the guide pin out on the left side of the drill
press head (A-Fig.19) and rotate 90
may be tilted to the desired angle.
3. Tighten the lock handle.
4. To return to the original position, loosen the lock
handle.
CONTINUED ON PAGE 13
A
C
Figure 15
ADJUSTMENTS
Clockwise and
o
. The head
o
ASSEMBLY
A
PLUGGED IN AND THE POWER SWITCH MUST BE IN THE
OFF POSITION UNTIL ALL ADJUSTMENTS ARE COMPLETE.
12
B
Figure 16
B
Figure 17
THE MACHINE MUST NOT BE
Figure 18
A
C
A
Advertisement
Table of Contents
