Table of Contents
Advertisement
Assistance is needed for
2. Place the drill press head (A-Fig. 6) onto the
column (B-Fig. 6) as far as it will go.
3. Attach the 2 clamping levers (part# 30B) on the
drill press column guide (part# 18B). Fig. 7.
4. Align the drill press head (A-Fig. 8) with the
base of the drill press.
5. Tighten the drill press head (A-Fig. 6) to the
column (B-Fig. 6) by tightening the locking
clamping lever (part# 30B) on the left side of
the guide column (part# 18B).
6. Attach the three feed handles (part# 35B) to
the hub (part# 36B). Fig. 8 .
THE MACHINE MUST NOT BE
PLUGGED IN AND THE POWER SWITCH MUST BE IN
THE OFF POSITION UNTIL ASSEMBLY IS COMPLETE.
INSTALLING & REMOVING THE CHUCK
AND ARBOR
IMPORTANT!
It is important that the chuck
and arbor are free of any grease or rust
protection. Use ordinary household grease
remover to clean the tapers.
INSTALLING THE CHUCK AND ARBOR
1. Open the chuck jaws as wide as possible to
prevent any damage. Fig. 9.
2. Insert the arbor (A-Fig.10) into the chuck
(B-Fig.10) as shown.
CONTINUED ON PAGE 11
ASSEMBLY
this next step.
B
Open Chuck Jaws
10
A
Figure 6
clamping levers
Figure 7
Figure 8
Figure 9
Advertisement
Table of Contents
