D-Link DVG-1402S User Manual page 45

Frequently Asked Questions (continued)
port, Authentication User Name, Authentication Password, and Confirm
Password.
Q: After setting up the DVG-1402S, I cannot surf the internet.
A: Re-check all the cabling installations. Make sure that the Ethernet cable
from the PC is plugged into one of the LAN ports of the DVG-1402S and the
Ethernet cable from the cable modem is plugged into the WAN port of the DVG-
1402S. Once this is verified but you still cannot access the Internet, then verify
the configurations via the Web GUI.
1) Access the Web GUI by entering the IP address: 192.168.15.1 in the
Address bar.
2) Select Configure WAN/LAN Access.
3) Select Configure WAN Port.
4) In the WAN Restart settings – Get IP from one of the following:
a. If using a cable modem - Choose DHCP and fill in the available
b. If using a DSL modem – Choose PPPoE and fill in the available
c. If the service provider gives a specific IP address – Choose
5) Once the DVG-1420S has rebooted, select Configure LAN Port.
6) Select Dynamic IP assignment.
7) In the "State" field, make sure that "Enabled" is selected.
8) Select "Save" and choose to reboot the DVG-1402S (not the PC).
9) Verify that the IP address on the PC has an address of 192.168.15.x ,
where "x" is a number assigned by the DVG-1420S.
information and click "Save". User will be prompted to either
"Save changes and reboot system now" or "Continue and
'Restart System' later". Choose "Save changes and reboot
system now" and wait for the unit to reboot (not the PC).
information and click "Save". User will be prompted to either
"Save changes and reboot system now" or "Continue and
'Restart System' later". Choose "Save changes and reboot
system now" and wait for the unit to reboot (not the PC).
Manual and enter the given information in the fields.
45