Configuring The Dvg-1402S For Dsl Connection - D-Link DVG-1402S User Manual

Getting Started (continued)
Connecting the DVG-1402S in Front of a Router
17. Reconnect the power to the Cable/DSL Modem (plug in or turn on the power
switch).
18. Reconnect the power to your existing Router (plug in or turn on the power
switch).
19. Restart your PC.
Next you must configure your DVG-1402S and PC. If you are using a DSL
Modem with a PPPoE or DHCP connection, you will need to continue on to the
following section. If you are using a Cable Modem, and your service provider
requires a MAC address, skip this section and refer to the section titled "MAC
Cloning for Cable Connection." Also be sure to change your computer's IP
settings to DHCP (to automatically be assigned an IP address from the DVG-
1402S) regardless of what type of internet connection you have. (Please refer
to your NIC card's manual for detailed information.) If your cable service provider
does not require a MAC address, setup of the DVG-1402S with a modem and
computer is complete.

Configuring the DVG-1402S for DSL Connection

Some Internet Service providers use PPPoE as their method of connecting
clients. If you have a PPPoE connection, you must follow the steps below to
complete the configuration of your hardware. If you are unsure of your connection
type, please check with your Internet Service Provider.
Open your Web browser and
type http://192.168.15.1 into
the URL address box. Press
the Enter or Return key.
15