D-Link DES-3226SM Reference Manual page 175

DES-3226S Layer 2 Fast Ethernet Switch User's Guide
config gvrp
port list.
pvid <value> − The PVID is used by the port
to tag outgoing, untagged packets, and to
make filtering decisions about incoming
packets. If the port is specified as tagging,
and an untagged packet is forwarded to the
prot for transmission, the port will add an
802.1Q tag using the PVID to write the VID
in the tag. When the packet arrives at its
destination, the receiving device will use the
PVID to make VLAN forwarding decisions. If
a packet is received by the port, and Ingress
Checking is enabled, the prot will compare
the VID of the incoming packet to its PVID.
If the two are unequal, the port will drop the
packet.
receive and forward the packet.
Restrictions Only administrator-level users can issue this
command.
Example Usage:
To sets the ingress checking status, the sending and receiving
GVRP information and Port VLAN ID(PVID):
DES3226S:4#config gvrp 1:1-1:5 state enabled
ingress_checking enabled pvid 21
Command: config gvrp 1:1-1:5 state enabled
ingress_checking enabled pvid 21
Success.
VLAN Commands
If the two are equal, the port will
175