DES-3226S Layer 2 Fast Ethernet Switch User's Guide
config stp
Purpose
Used to setup STP on the switch.
Syntax
config
<value>/forwarddelay
<value>/fbpdu [enabled/disabled]}
Description
This command is used to setup the Spanning
Tree Protocol (STP) for the entire switch.
Parameters
maxage <value> − the maximum amount of
time (in seconds) that the switch will wait to
receive a BPDU packet before reconfiguring
STP. The default is 20 seconds.
hellotime <value>
between
messages by the root device. The default is 2
seconds.
forwarddelay <value>
amount of time (in seconds) that the root
device will wait before changing states. The
default is 15 seconds.
priority <value>
between 0 and 65535 that is used in
determining the root device, root port, and
designated port. The device with the highest
priority becomes the root device. The lower
the numerical value, the higher the priority.
The default is 32,768.
fbpdu [enabled/disabled]
forwarding of STP BPDU packets from other
network devices when STP is disabled on the
104
stp
{maxage
<value>/hellotime
<value>/priority
−
the time interval
transmission
of
configuration
−
the maximum
−
a numerical value
−
Spanning Tree Commands
allows the