D-Link DES-3226SM Reference Manual page 112

DES-3226S Layer 2 Fast Ethernet Switch User's Guide
show stp ports
Purpose Used to display the switch's current per-port
group STP configuration.
Syntax show stp ports <portlist>
Description This command displays the switch's current
per-port group STP configuration.
Parameters <portlist> −
configured. The port list is specified by listing
the lowest switch number and the beginning
port number on that switch, separated by a
colon. Then highest switch number, and the
highest port number of the range (also
separeted by a colon) are specified.
beginning and end of the port list range are
seperated by a dash. For example, 1:3 would
specify switch number 1, port 3. 2:4 specifies
switch number 2, port 4. 1:3-2:4 specifies all
of the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order.
Restrictions none
Example Usage:
To display STP state of port 1-9 of module 1.
DES3226S:4#show stp_ports 1:1-1:9
Port Connection State Cost
112
specifies a range of ports to be
Priority Status STP
Spanning Tree Commands
The