D-Link DES-3226SM Reference Manual page 153

DES-3226S Layer 2 Fast Ethernet Switch User's Guide
config 802.1p default_priority
Purpose Used to configure the 802.1p default priority
settings on the switch. If an untagged packet
is received
configured with this command will be written
to the packet's priority field.
Syntax config 802.1p default_priority
[<portlist>/all] <priority>
Description This command allows you to specify default
priority handling of untagged packets received
by the switch. The priority value entered with
this command will be used to determine which
of the four hardware priority queues the
packet is forwarded to.
Parameters <portlist> − This specifies a range of ports for
which the default priority is to be configured.
That is, a range of ports for which all untagged
packets received will be assigned the priority
specified below. The port list is specified by
listing the lowest switch number and the
beginning
separated by a colon.
number, and the highest port number of the
range (also separeted by a colon) are specified.
The beginning and end of the port list range
are seperated by a dash.
would specify switch number 1, port 3.
specifies switch number 2, port 4.
specifies all of the ports between switch 1, port
3 and switch 2, port 4 − in numerical order.
all − Specifies that the command applies to all
QOS Commands
by the switch, the
port number on that
Then highest switch
For example, 1:3
priority
switch,
2:4
1:3-2:4
153