D-Link DES-3226SM Reference Manual page 147

DES-3226S Layer 2 Fast Ethernet Switch User's Guide
config scheduling
number
hardware priority queue will be allowed to
transmit before allowing the next lowest
priority queue to transmit its packets. A value
between 0 and 255 can be specified.
max_latency <value> − Specifies the maximum
amount of time the above specified hardware
priority queue will be allowed to transmit
packets before allowing the next lowest
hardware priority queue to begin transmitting
its packets. A value between 0 and 255 can be
specified − with this value multiplied by 16 ms
to arrive at the total allowed time for the
queue to transmit packets.
value of 3 specifies 3 X 16 = 48 ms. The queue
will continue transmitting the last packet until
it is finished when the max_latency timer
expires.
Restrictions Only administrator-level users can issue this
command.
Example Usage:
To configure the user password of "dlink" account :
DES3226S:4# config scheduling 0 max_packet 100
max_latency 150
Command: config scheduling 0 max_packet 100
max_latency 150
Success.
QOS Commands
of packets the above
For example, a
specified
147