D-Link DES-3226SM Reference Manual page 174

DES-3226S Layer 2 Fast Ethernet Switch User's Guide
config gvrp
Purpose Used to configure GVRP on the switch.
Syntax config gvrp [<portlist>/all] {state
[enabled/disabled]/ingress_checking
[enabled/disabled]/pvid <value>}
Description This command is used to configure the Group
VLAN Registration Protocol on the switch.
You can configure ingress checking, the
sending and receiving of GVRP information,
and the Port VLAN ID (PVID).
Parameters <portlist> − A range of ports for which you
want ingress checking.
specified by listing the lowest switch number
and the beginning port number on that
switch, separated by a colon. Then highest
switch number, and the highest port number
of the range (also separeted by a colon) are
specified. The beginning and end of the port
list range are seperated by a dash.
example, 1:3 would specify switch number 1,
port 3. 2:4 specifies switch number 2, port 4.
1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in
numerical order.
all − Specifies all of the ports on the switch.
state [enabled/disabled] − Enabled or disables
GVRP for the ports specified in the port list.
ingress_checking [enabled/disabled] − Enables
or disables ingress checking for the specified
174
The port list is
For
VLAN Commands