To Change The Spray Pattern (Narrow Jet / Wide Spray); Adjusting The Pressure - Clarke JETSTAR 1850 Operation & Maintenance Instructions Manual

4. Release the trigger lock.
• The pressure washer is now
ready for use.
5. Make sure that you have a firm
footing and are also holding the
gun and spray lance firmly.
• Expect the spray gun to 'kick'
when starting.
6. Pull the trigger on the gun to start water flow.
• If you release the trigger the device will switch off again, the system
remains under high pressure.
• During longer breaks (more than 5 minutes), turn the pressure washer off.
See "Shutting Down" on page 11.
7. Once the machine has been turned off, release any residual pressure in
the system by turning off the water supply and operating the trigger before
disconnecting any hose or accessory.
ADJUSTMENTS

TO CHANGE THE SPRAY PATTERN (NARROW JET / WIDE SPRAY)

1. Hold the shaft of the lance in one
hand.
2. To vary the spray between narrow
and wide, turn the nozzle counter-
clockwise through a half-of-a-turn
(180°).

ADJUSTING THE PRESSURE

Increasing the distance you are from the surface being cleaned and adjusting
the spray to a wider angle (lowers the pressure).
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
9