SPARE PARTS & SERVICE CONTACTS For Spare Parts and Service,please contact your nearest dealer, or CLARKE International, on one of the following numbers. PARTS & SERVICE TEL: 020 8988 7400 PARTS & SERVICE FAX: 020 8558 3622 e-mail as follows: PARTS: Parts@clarkeinternational.com...
This CLARKE product is guaranteed against faulty manufacture for a 2. Pressures in system 2. Refer to starting period of 12 months from the date of purchase. Please keep your receipt uneven procedure p6.
SAFETY PRECAUTIONS ACCESSORIES The range of accessories listed below may be purchased from your CLARKE WARNING! dealer. Water at high pressure can be dangerous and may cause severe damage Item Part No. to persons or property if subject to misuse.
Jet 3000 ELECTRICAL CONNECTIONS WARNING: THIS MACHINE MUST BE EARTHED. This product is provided with a standard 13 amp, 230 volt (50Hz), BS 1363 plug, for connection to a standard, domestic electrical supply. Should the plug need changing at any time, ensure that a plug of identical specification is used.
The outlet on the Jetstar 1550 and 1600 models is at the front of the unit - opposite end to power cable inlet, on the Jet 3000 model, it is mounted on the front - handle end.
Thread the hex. wrench (supplied), through the hole in the cover, at the centre of the rear of On the Jetstar 1550 and 1600 models, the switch is a rotary type mounted on the the unit, (see Fig.1), and into the hex. socket left side front of the unit.
Use ONLY those If cleaning agents have been used, thoroughly clean the detergent lance and detergents recommended for use with power washers, such as CLARKE Traffic Film bottle with clean water.