Maintenance; Cleaning The Nozzle; Cleaning The Water Inlet Filter - Clarke JETSTAR 1850 Operation & Maintenance Instructions Manual

MAINTENANCE

WARNING: REMOVE THE PLUG FROM THE SOCKET-OUTLET BEFORE
CLEANING OR MAINTENANCE AND WHEN REPLACING PARTS

CLEANING THE NOZZLE

If the nozzle becomes partially clogged with foreign material such as dirt or
limescale, excessive pressure may develop and the pump pressure will
pulsate. Clean the nozzle immediately as follows:
1. Turn off the power washer and
turn off the water supply.
2. Pull the trigger to relieve any
water pressure.
3. Disconnect the lance from the
spray gun.
4. Remove any obstructions by
directing the water supply into the
end of the lance for 30 seconds to
back flush loose particles.
5. If flushiing does not dislodge the obstruction, carefully use the nozzle
cleaning tool, to clear the nozzle.
6. Reconnect the lance to the gun and turn on the water supply.

CLEANING THE WATER INLET FILTER

This filter should be checked periodically and cleaned if necessary.
1. Remove the inlet filter from the
pressure washer as shown.
2. Clean the filter by flushing both
sides with water.
3. Replace the filter into the water
inlet.
• The tapered side faces in.
NOTE: Do not operate the pressure
washer without the filter
installed.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
12