Connecting The Mains Water Supply; Operation - Clarke JETSTAR 1850 Operation & Maintenance Instructions Manual

CONNECTING THE MAINS WATER SUPPLY

NOTE: Always follow the regulations of your local water supplier.
1. Screw the inlet adaptor to the
water inlet as shown.
2. Connect the supply hose to the
inlet adaptor.
• A standard garden hose or a
reinforced hose with an inner
diameter of at least 10 mm
available from your CLARKE
dealer will be suitable.
3. Connect the supply hose to the
water supply.
• The water supply must provide a minimum of 6 litres per minute at a
maximum of 40°C.
4. Open the water tap fully.

OPERATION

1. Turn the water supply on, making sure that the tap is fully open.
WARNING: FAILURE TO TURN ON THE WATER FULLY COULD CAUSE
DAMAGE TO THE POWER WASHER INTERNAL COMPONENTS.
WARNING: DO NOT USE THE POWER WASHER IF THE SUPPLY CABLE OR
IMPORTANT PARTS OF THE MACHINE ARE DAMAGED, E.G. SAFETY
DEVICES, HIGH PRESSURE HOSES, TRIGGER.
WARNING: WE RECOMMEND THAT THIS MACHINE IS CONNECTED TO THE
MAINS SUPPLY VIA A RESIDUAL CURRENT DEVICE (RCD).
2. Plug the mains power cable into
the electricity supply.
3. Set the switch to the ON position.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
8