Option Programming - CrimeStopper RS-800 Installation Instructions Manual

This system has several installer programmable features as listed in the chart below.

Option Programming:

1. Open hood (Gray wire grounded)
2. Turn Key to the ON position
3. Press program button 5 times, after a few seconds the unit will flash the lights 5 times.
4. Push the valet/program button [again] the number of times that corresponds to the option number desired. You
should get a light flash after each button press.
5. A) For RS800: When you reach the desired programming level, Press button #1(Lock) or #2 (Start) to change
the option. See the chart below for option values and descriptions. See chart below.
5. B) For RS801: (No remotes) Tap the brake pedal once to change the option (Same as pressing Button 1 on a
remote). To reset the option back to Default, tap the brake pedal 2 times (Same as pressing Button #2 on a
remote)
6. Turn Ignition OFF, Close hood and check for changed features. Change each option individually repeating STEPS
1-5 above.
Option # Option Description
1 NOT USED
2 Door Lock Pulse Time
3 Double Unlock Pulse
4 Tach Learning
5 Remote Start Engine
Run Time
6 Option reset
OPTION PROGRAMMING
OPTIONS CHART
Option Values
NOT USED
0.75 Sec. (Standard) OR
3.0 Sec. (European Vacuum)
ON or OFF
See Tach Reference
Programming
Button #1 = 48 Min.
Button #2 = 24 Min.
Button #2
Button #1 Button #2
LOCK START
(Default)
3 Sec. 0.75 Sec.
ON OFF
Learn Tach
24 Min. 36 Min.
Reset ALL to
Default