CrimeStopper RS-800 Installation Instructions Manual page 9

TACH REFERENCE PROGRAMMING:
1. Open hood (Gray wire must be grounded).
2. Connect WHITE/RED wire to a valid Tach source.
3. Start engine with key.
4. Press program button 5 times, then wait for 5 light flashes.
5. Wait at least one second then push program button slowly (4) times, you should get a light flash after each button
press. This unit is now at option #4-Tach Learning.
6. A) RS800: Press Button #1 remote transmitter. The unit will read the Tach source and flash the lights twice for
program confirmation.
6. B) RS801: (No Remotes) Press the brake pedal to program the Tach Source.
7. If lights do not flash twice for confirmation, then try another tach source and repeat Steps 1-6 above.
NOTE: The RS800/801 will operate in "Smart" Tachless Mode [by default] unless a Tach Reference has been
programmed. When a Tach Reference is programmed, this automatically takes the unit out of "Smart" Tachless"
Mode.
FAIL SAFE PROTECTION:
If the WHITE/RED TACH input wire becomes disconnected due to wear and tear or when the vehicle is serviced, the
RS800/801 will automatically go into "Smart" Tachless" mode to allow the unit to continue starting the engine.
Transmitter Code Learning:
Note: All transmitter codes must be learned at time of programming!! The RS800 allows storage of up to 4
different transmitter codes.
1. Open Hood. (Ground Gray wire.)
2. Turn key to the ON position.
3. Press Programming button 4 times, then after a few seconds the unit will flash the parking lights 4 times.
4. Press button #1 of the transmitter to be coded. You should get 2 light flashes indication the unit is waiting for a 2
code, then press button #1 of a second transmitter, the unit will flash 3 times indicating its waiting for the 3
lights will flash 4 times for 4
otherwise turn key OFF and close hood.
TACH REFERENCE MODE
TRANSMITTER PROGRAMMING (RS800ER ONLY)
th
code. If all 4 codes are learned, the unit will automatically exit code learning mode,
nd
rd
code and