"Smart" Tachless Mode - CrimeStopper RS-800 Installation Instructions Manual

REVERSE POLARITY DOOR LOCK WIRING
GREEN
RED
BLUE
85
87A
MASTER
SWITCH
+
L
UL
CUT
This RS800 includes custom monitoring circuitry allowing the unit to start an engine without the use of a Tach Wire. The
module actively monitors the vehicle over the life of the installation regardless of weather or battery conditions. The
"Smart" Tachless Mode circuitry allows the remote start system to compensate for most conditions over life of the vehicle
while adjusting by itself for optimum starting capabilities.
IMPORTANT NOTE: Vehicles with more than one battery may give out inconsistent voltage readings. This may result in
poor performance when using "Smart" Tachless Mode. Use a Tach wire and program a Tach source when installing an
RS800/801 on vehicles using 2 [or more] Batteries.
TO SET SMART TACHLESS MODE: (No Tach Wire Required)
1) DO NOT START VEHICLE! Turn IGN ON, turn HEADLIGHTS ON and FAN BLOWER ON HIGH for 2-3 minutes to
drain off excess surface charge on the vehicle's battery.
2) After 2-3 minutes, connect the (2) RED +12V input wires to the Module.
3) The unit will automatically read and program itself for your vehicle when voltage is applied.
POWER DOOR LOCK WIRING
FUSED
+12V
+
85 86
86
87 87
30 87A 30
CUT

"SMART" TACHLESS MODE

AFTERMARKET MOTOR/DOOR LOCK WIRING
GREEN
RED
BLUE
85 86
87
87A 30
FUSED
+12V
+
85 86
87
87A 30