Diesel Glow Plug Delay; Option Programming - CrimeStopper Cool Start RS-00 Installation Instructions Manual

This feature provides a solution for diesel vehicles without having to connect to the Glow Plug-Wait to Start Circuit. This
may be needed for various reasons. If your vehicle does not have a viable Wait to Start Circuit, or you cannot locate and
identify the circuit, then change your system to Diesel Glow Plug Delay mode. You can choose from a selection of pre-
cranking delay times. Once this mode is activated, the system will NO LONGER monitor the PINK glow plug input wire
and will use a delay setting chosen by the installer in the option chart.
NOTES: This feature is OFF by default and must be programmed before use. Once this feature is turned ON, the Pink
Glow plug input wire is not used. The Remote start unit will always wait the programmed time before cranking EVEN IF
the glow plug warms up first. There are 3 different Delay times available for use: 10, 15, or 20 seconds. SEE OPTION
PROGRAMMING CHART on Pages 15-16.
This system has 28 programmable options to customize operating features and installer preferences. You may change
one option at a time, or program multiple options in one session. If you start with the lowest option and continue on to
higher options, you do not need to repeat steps #1-3 each time. For example, you can change Option #2 to "ON", then
you can continue pressing the program button to get to a higher number option and change it as well.
To Engage Option Programming:
1. Turn Ignition Key to the ON position. Do not start vehicle.
2. Press the Program / Valet button 5 times. Wait for the unit to flash the lights and/or horn honk 5 times.
3. Push the valet program button the number of times that corresponds to the option number desired (1-28X). You must
get a light flash and/or honk after each button press. If the system did not flash the lights and/or honk, then it did not
register your press. Press carefully and do not lose count.
4. For RS3, RS4, RS7: When you reach the desired option #, to change the option: Press button #1 Lock, #2 Unlock,
#3 Trunk, #4 Start. (Some option numbers use ALL 4 remote buttons to select settings)
5. For RS00, RS1: (No Lock button) Tap the brake pedal to toggle through the option values: Tap brake once (lights
flash 1X) Tap the brake pedal again (Lights flash 2X) tap 3 or 4 times for options that have 3 or 4 values.
6. When finished, turn Ignition OFF, and check for changed features.

DIESEL GLOW PLUG DELAY

OPTION PROGRAMMING

14