Option Programming Table - CrimeStopper RS2-G3 Installation Instructions Manual

To Engage Option Programming:
1. Turn Ignition On (must be off at least 5 seconds before turning on).
2. Within 8 seconds, press valet switch 5 times. Wait for the unit to flash the parking lights and/or horn honks 5
times to confirm entering Option Mode.
3. Push the Valet program button the number of times that corresponds to the option number desired (1-24X). You
must get a light flash and/or horn honk after each button press. If the system did not flash the lights and/or honk,
then it did not register your press. Each option must be changed within 20 seconds.
4. When you reach the desired option #, press the transmitter button or step on footbrake to select the option level.
The lights will flash and/or honk with each option level. You will get 1, 2, 3 or 4 chirps with each press.
a. If there is no option level 3 or 4, then it returns the Preset value with 1 chirp.
b. After 20 seconds or turning ignition off, the system will have a long beep and exit the Option Mode.
Option Selection
1 Engine Monitoring
2 Auto-lock/unlock
3 Lock pulse timer
4 Pink/white wire selection
5 Data port protocol
6 Gray wire selection
OPTION PROGRAMMING
OPTION PROGRAMMING
Default Level 2
(1 chirp) (2 chirps)
Tachless
(low level)
OFF
0.5 Seconds 3 seconds
IGN
Fortin ADS iDatalink
ACC
14
Level 3
(3 chirps)
Tachless
Tach
(high level)
ON Lock with brake
Double unlock
ACC START
D2D
IGN START
Level 4
(4 chirps)
Timed Crank
(hybrid)
Ignition Lock
(no unlock)
"Wake Up" pulse on
Unlock