CrimeStopper RS-800.III Operating Instructions

Series iii remote engine starting system

Hide thumbs Also See for RS-800.III:

Download this manual See also: Instruction and Installation Manual

CRIMESTOPPER SECURITY PRODUCTS, INC. and its VENDORS shall not be liable for any accident resulting from

the use of this equipment. This system is designed to be professionally installed onto a vehicle in which all items, such

as parking brake and all associated components, door switches, transmission shift linkage, throttle linkage, and all

engine safety features, are in perfect working condition.

DO NOT install this Remote Engine Starting System on MANUAL TRANSMISSION vehicles. If accidentally left in

gear the vehicle could become a self-propelled threat to life and property.

IT IS ABSOLUTELY THE OWNER'S SOLE RESPONSIBILITY TO: A) Understand the operation of this system and its

safety features. B) Check for proper operation of these safety features prior to accepting delivery of the vehicle from the

installation facility. C) Check and maintain the condition of the vehicle and all items relative to the proper operation of

this system and its safety features. D) Always leave the doors and windows closed and locked to protect against

accident and theft.

DO NOT remote start the vehicle in a closed garage. Make sure that the garage door is open or there is adequate

ventilation. Failure to observe this rule could result in injury or death from poisonous Carbon Monoxide fumes.

REV. A 09/2002

RS800 Series

Remote Engine Starting System

OPERATING INSTRUCTIONS

OPERATION CAUTIONS & WARNINGS

This device complies with FCC Rules part 15. Operation is subject to the following two conditions: 1)

This device may not cause interference, and (2) this device must accept any interference that may be

received, including interference that may cause undesired operation. The manufacturer is not

responsible for any radio or TV interference caused by unauthorized modification to this equipment.

Such modification could void the user's authority to operate the equipment.

III

Page 1: Operating Instructions
OPERATION CAUTIONS & WARNINGS CRIMESTOPPER SECURITY PRODUCTS, INC. and its VENDORS shall not be liable for any accident resulting from the use of this equipment. This system is designed to be professionally installed onto a vehicle in which all items, such as parking brake and all associated components, door switches, transmission shift linkage, throttle linkage, and all engine safety features, are in perfect working condition.
Page 2 REMOTE ENGINE STARTING - SUCCESSFUL START: 1. Press and release the remote start button. 2. Parking lights flash once, then turn ON along with the IGN/ACC circuits 3. After a few seconds the Starter Motor engages. (Parking lights and Acc circuits turn off while cranking.) 4.
Page 3 ANTI-GRIND / STARTER DISABLE (OPTIONAL) Prevents the driver from accidentally grinding the starter if the Ignition key is turned too far (to the start position) while engine is already running from the remote starter. Starter circuit is automatically disabled when doors are locked using the remote control to act as an added security feature.
Page 4 AT VEHICLE #2 and learn YOUR remote, along with Car 2’s existing remotes. Transmitter programming steps are listed on previous page. CAR I / CAR II OPERATION CAR I START Slide CAR II RS 800 III Crimestopper Security Products Inc. 1770 S. Tapo St. Simi Valley, CA 93063 (800) 998-6880 www.crimestopper.com...

Rs-800