Table of Contents
Advertisement
IMPROVED: Now you can program multiple options in one session if you start with the lowest option and continue on to
higher options [if needed] without repeating the steps #1-3. For example, you can change Option #2 to "ON" by pressing
the lock button, then you can continue pressing the program button to get to a high number option and change it as well
without having to repeat Steps 1-5. You can only go from low to higher options numbers in one session.
Option Programming:
1. Open hood (Ground the Gray wire if no hood pin is installed).
2. Turn Key to the ON position
3. Press program button 5 times, after a few seconds the unit will flash the lights 5 times.
4. Push the valet/program button [again] the number of times that corresponds to the option number desired. You
should get a light flash after each button press. If the system did not flash the lights, then it did not register your
press.
5. When you reach the desired programming level, Press button #1(Lock) or #2 (Start) to change the option. See
the chart below for option values and descriptions.
6. Turn Ignition OFF, Close hood and check for changed features.
Option
Option Description
#
1
NOT USED
2
Door Lock Pulse Time
3
Double Unlock Pulse
4
Engine Monitoring
5
Remote Start Engine Run
Time
6
Smart Tachless Voltage
Adjust (80-100%) Only when
Option #4 is set to Tachless
7
Option reset
OPTION PROGRAMMING
OPTIONS CHART
Option Values
0.75 Sec. (Standard) OR
3.0 Sec. (European Vacuum)
ON or OFF
Tach (Engine RPM) or
Tachless Mode
Button #1 = 48 Min.
Button #2 = 24 Min.
Button #1 = Decrease by 1%
Button #2 = Increase by 1%
Button #2
12
* = DEFAULT
Button #1
Button #
LOCK
START
3 Sec.
0.75 Sec.*
ON
OFF*
Learn Tach
Tachless*
36 Min.
24 Min*.
-1%
+1%
Reset to
Default
Advertisement
Table of Contents
