Diesel Glow Plug Delay; Option Programming - CrimeStopper RS-999.FM Installation Instructions Manual

This feature provides a solution for diesel vehicles without having to connect to the Glow Plug-"Wait to Start Circuit".
This may be needed for various reasons. If your vehicle does not have a viable "Wait to Start Circuit", or you cannot
locate and identify the circuit, then change your system to "Diesel Glow Plug Delay" mode. You can choose from a
selection of "pre-cranking" delay times. Once this mode is activated, the RS-900/901/999 system will NO LONGER
monitor the PINK glow plug input wire and will use a delay setting chosen by the installer in the option chart.
NOTES: This feature is OFF by default and must be programmed before use! Once this feature is turned ON, the Pink
Glow plug input wire is not used. The Remote start unit will always wait the programmed time before cranking EVEN IF
the glow plug warms up first. There are 3 different Delay times available for use: 10, 20, or 30 seconds. SEE OPTION
PROGRAMMING CHART on Page 17.
HOW TO USE THIS FEATURE:
1. See the "Option Programming" section on Pages 15-19 and change Option #17 from "Monitor Glow Plug Light" to
one of the delayed time values. (Default setting is to always monitor the PINK Glow Plug input wire.)
2. Once this option has changed the RS-900/901/999 system will wait for the selected time before cranking.
IMPROVED: Now you can program multiple options in one session if you start with the lowest option and
continue on to higher options [if needed] without repeating the steps #1-3. For example, you can change Option
#2 to "ON" by pressing the lock button, then you can continue pressing the program button to get to a high
number option and change it as well without having to repeat Steps 1-5. You can only go from low to higher
options numbers in one session.
To Engage Option Programming:
1. Open hood (ground the Gray wire if no hood pin switch is installed)
2. Turn Key to the ON position
3. Press program / valet button 5 times. After a few seconds the unit will flash the lights 5 times.
4. Push the valet/program button [again] the number of times that corresponds to the option number desired (1-
20X). You must get a light flash after each button press. See chart on next page for option list.
5. A) For RS900/999FM: When you reach the desired programming level, Press button #1(Lock) or #2 (Unlock) to
change the option. (Options 16, 17, and 18 use all 4 transmitter buttons.)
5. B) For RS901 (No remotes) Tap the brake pedal to toggle through the option values: Tap the brake once
(lights flash 1X; Tap the brake pedal again (Lights flash 2X) tap 3 or 4 times for options that have 3 or 4 values.
6. Turn Ignition OFF, Close hood and check for changed features.

DIESEL GLOW PLUG DELAY

OPTION PROGRAMMING [IMPROVED]