B&D EconoLift Installation Instructions Manual page 14

13. FITTING THE SAFETY PHOTO
ELECTRIC BEAM SENSOR (OPTIONAL)
Locate the Photo Electric Beam (P.E.) normally closed contact
type in a strategic location within doorway. We recommend
150mm above the floor level and as close as possible to the
door opening, inside the garage. Remove shunt from P.E
connector (Fig. 14) and connect the wires from the P.E. wiring
harness as per Fig. 15.
Note: The wiring diagram is for a Transmitter/Receiver type
photo electric beam: model: PE-2 (Order Code 90214) with
Wiring Harness (Order Code 01900).
Make sure to align the beams correctly. Follow the manual
supplied with the Photo Electric Beam.
WARNING; The location of the beam and manner in which
it is installed might not give safety protection at all times.
Check to make sure that the height of the beam and type
used give maximum protection possible.
14. MANUAL RELEASE
To switch the opener to manual mode simply pull the red
manual release handle down and release. To re-engage the
opener repeat the above action (Fig. 16).
Note: The door may move uncontrollably if the spring tension
is weak or not set properly or the door is unbalanced. If this
occurs do not use the door and contact your installer for
service.
The manual release handle can be locked to prevent unwanted
disengagement (where fitted). This is useful if the opener is
mounted on an exposed carport or perimeter door. To disable
the manual release turn the key clockwise to the locked position
as indicated on the label. To enable turn the key anti-clockwise.
15. RESET ALL FACTORY DEFAULTS
1. Turn power off.
2. Press and hold Set button.
3. Turn power on and continue holding Set until all LEDs are
off.
Note: This does not erase transmitter codes stored in memory.
16. RE-INITIALISING THE OPENER
To re-initialise the opener press and hold the Set Button for two
(2) seconds, the beeper will sound once. The door will start to
move and re-calculate force margins. The door can move
between the open and close limit positions up to four (4) times
(depending on the position of the door and the power up
condition). A single beep will be heard once the initialisation is
complete. The door is now ready for use.
©Copyright 2006 B&D Doors
PE BEAM AND FINAL SET UP
REMOVE
PE SHUNT
Model: PE-2
1 2 3 4 5
14
FIG. 14
FIG. 15
0V
PE
24V
FIG. 16