Coding Transmitters; 11. Locking The Control Panel - B&D EconoLift Installation Instructions Manual

9. SETTING TRANSMITTERS CODES
Make sure to insert the battery into the transmitter. The
memory in the openers receiver can store up to six smart code
remote control transmitters, one dipswitch transmitter and one
entry keypad.
10.1 STORING THE TRANSMITTERS CODE
1. Press and hold the Door Code button (Fig. 13).
2. Press the button on the transmitter for two seconds, pause
for two seconds. Press the button again on the transmitter for
two seconds.
3. Release the Door Code button.
4. Press the transmitter button to test if it operates the door.
10. DELETING PROGRAMMED CODES
10.1 DELETING A STORED TRANSMITTER CODE
1. Select the transmitter you want to delete.
2. Press and hold the Door Code button (Fig. 13).
3. Press the transmitter button you would like to delete for two
seconds. Pause for two seconds. Press the transmitter button
again for two seconds.
4. Release the Door Code button. The code should now be
deleted. Confirm this by pressing the transmitter button, the
door should not respond.
10.2 - SETTING OPTIONAL REMOTE CONTROL
TRANSMITTER DIPSWITCH CODES.
Some remote control transmitters have a dip-switch facility.
Generally, dipswitches are used when several persons are
operating the same opener. The dip-switches must be set to
matching positions in all remotes used to activate the opener.
1. Remove the battery cover.
2. Set switches in all remote controls to matching positions
(+, -, 0). Use a pen or screwdriver (Fig 14).
3. Replace covers and program this code.
10.3 - SETTING ENTRY KEYPAD TRANSMITTER
CODE.
1. Make sure that the battery is set in the Key Pad
Transmitter.
2. Press the Code Set button on the opener, the Code Set LED
will illuminate to indicate the opener is in Code Learn
mode. (if a valid code is not stored within 15 seconds, the
opener will exit Code Learn).
3. For an entry keypad the desired code should be typed (a
minimum of four numbers or letters) and the ENTER
button held down until the Code Set LED flashes to
indicate that it has been learnt.
4. Release the button on the key pad transmitter.
The code is now set.
©Copyright 2006 B&D Doors

CODING TRANSMITTERS

Press and hold
Door Code
Button
10.4 DELETING ALL STORED TRANSMITTER CODES
1. Turn the power off to the opener.
2. Press and hold the Door Code button (Fig. 13).
3. Turn the power on again while holding the Door Code
button. The Open Limit, Close Limit and Door Status LED's
will illuminate for about five seconds. These LED's will turn
Off and the Coding LED will illuminate. Release the Door
Code button. All the stored codes should now be deleted.
Confirm this by trying to operate the door by pressing the
transmitters previously used to control the door, the door
should not respond.

11. LOCKING THE CONTROL PANEL

To lock or disable the control panel a transmitter button must be
coded for the operate function.
1. Press and hold Plus (+) button for 4 seconds until you hear
a beep.
2. Press a coded transmitter button.
3. To test press the Operate button to confirm that the door
does not move.
To unlock the control panel repeat the above procedure.
13
FIG. 13
FIG. 14