Fixing Curtain To Drum - B&D EconoLift Installation Instructions Manual

5. FIXING OF DOOR CURTAIN TO DRUM
WHEEL
The door curtain has to be secured to the drum wheel with
suitable fasteners.
1. With the door in the fully closed position, mark the curtain
(Fig. 7) on both ends of the door.
2. Open door slightly to have access to the marked positions.
Secure the curtain to drum wheel using self drilling screws
(two on each end). The screws should be at least 90 degrees
apart.
6. SETTING DOOR TRAVEL LIMITS
IMPORTANT NOTE: The OPERATE button will not
function until the open and close limits positions are set.
6.1 SETTING DATUM POSITION
1. Switch the opener into manual mode (Fig. 8).
2. Move the door by hand to an approximately mid open
position.
3. Re-engage the opener.
4. Using a small blade screw driver turn the datum adjust
screw slowly until the yellow status LED just illuminates.
Note: If the status LED is already illuminated when power is
connected then turn the datum adjust screw until the LED goes
off then turn back one notch to illuminate again.
©Copyright 2006 B&D Doors
SETTING LIMITS
10
FIG. 7
DRUM WHEEL
FIG. 8
FIG. 9