Hardware Hookup - Crestron TPS-IMC-BV Operation Manual

Crestron TPS-IMC-BV
Hardware Hookup for the TPS-IMC-BV
* CONNECT
TO PC
VIDEO
PORT
** CONNECT
TO
VIDEO
SOURCE
CONNECT TO
POWER PACK
(OPTIONAL)
CONNECT TO
CONTROL
SYSTEM OR
CRESNET
PERIPHERALS
* Connect to a PC video port only if the TPS-XVGA-BV expansion card is installed in the touchpanel.
** Connect to a video source only if the TPS-VID expansion card is installed in the touchpanel. The
BNC connectors and RJ45 connector are connected in parallel. Use one or the other. For unbalanced
video, use the coax cable connectors. For balanced video, use the RJ45.
Operations Guide - DOC. 5921

Hardware Hookup

The TPS-IMC-BV serves as an interface between the touchpanel and the Cresnet
system. Refer to the illustration after this paragraph for proper connections; apply
power last. When making network connections to the control system or Cresnet
peripherals, refer to "Network Wiring" on page 5. It is not necessary to make
connections to a video source or PC video port unless the TPS-VID or
TPS-XVGA-BV, respectively, has been installed into the touchpanel. Connections to
video source also require that a video window object reside on a page within the
uploaded VisionTools™ Pro-e project.
Interface Module
CONNECT
TO DEVICE
AUDIO INPUT
CONNECT
TO AUDIO
SOURCE
CONNECT
TO AUDIO
SWITCHER
CONNECT
TO
TPS-5000
OR
TPS-6000
VIA
TRIAMESE
CABLE
Interface Module: TPS-IMC-BV 7