Hardware Hookup - Crestron TPMC-CH-IMC Operation Manual

CAT5 Balanced AV Interface Module

Hardware Hookup

Make the necessary connections as called out in the illustration that
follows this paragraph. Refer to "Network Wiring" on page 9 before
attaching the 4-position terminal block connector. Apply power after all
connections have been made.
It is not necessary to make connections to a video source unless a video
window object resides on a page within the uploaded Creston
VisionTools
When making connections to the TPMC-CH-IMC, use Crestron power
supplies for Crestron equipment.
Hardware Connections for the TPMC-CH-IMC
AUDIO (TO PANEL)
BALANCED AUDIO OUT AND MIC
IN OVER CAT5 (BLUE)
VIDEO (TO PANEL)
BALANCED VIDEO OUT OVER
CAT5 (RED)
CRESNET (TO PANEL)
SENDS AND RECEIVES CRESNET
SIGNALS BETWEEN TOUCHPANEL
AND CONTROL SYSTEM
A triamese cable included with the touchpanel has an RJ-45 connector
with a blue cover to match the blue label on the TPMC-CH-IMC and an
RJ-45 connector with a red cover to match the red label on the
TPMC-CH-IMC. The cable also has a 4-position mini terminal block
connector for making a network connection between the touchpanel and
the TPMC-CH-IMC.
10 • CAT5 Balanced AV Interface Module: TPMC-CH-IMC
®
Pro-e (VT Pro-e) project.
Crestron TPMC-CH-IMC
AUDIO OUT
PROVIDES BALANCED LINE-
LEVEL MICROPHONE AUDIO
AUDIO IN
BALANCED AND UNBALANCED
LINE-LEVEL AUDIO SOURCES
Pr
UNBALANCED "Pr" FOR YPbPr
C/Pb
UNBALANCED "C" FOR S-VIDEO
OR UNBALANCED "Pb" FOR YPbPr
COMP/Y/Y
UNBALANCED COMPOSITE
VIDEO, UNBALANCED "Y" FOR
S-VIDEO OR UNBALANCED "Y"
FOR YPbPr
CRESNET
TO CONTROL SYSTEM AND
OTHER CRESNET DEVICES
Operations Guide – DOC. 6345A