Hardware Hookup - Crestron PSPHD Operation Manual

PROCISE 7.3 Surround Sound Processor
Stacking
Connect the Device
26 • PROCISE 7.3 Surround Sound Processor: PSPHD
Ear Attachment for Rack Mounting
4. Repeat procedure (steps 1 through 3) to attach the remaining ear to the
opposite side.
Four "feet" are integrated into the PSPHD so that if the unit is not rack mounted, the
feet can provide stability when the unit is placed on a flat surface or stacked.
NOTE: No more than two PSPHD units should be stacked.
NOTE: If the PSPHD is to be rack mounted, the feet should be removed with a #2
Phillips screwdriver prior to "Hardware Hookup", which starts below.

Hardware Hookup

Make the necessary connections as called out in the illustration that follows this
paragraph. Refer to "Network Wiring" on page 24 before attaching the 4-position
terminal block connector. Apply power after all connections have been made.
When making connections to the PSPHD, note the following:
• Use Crestron power supplies for Crestron equipment.
• The included cable cannot be extended.
WARNING: To prevent injury and / or equipment damage due to electric shock,
disconnect power from the PSPHD prior to making any wiring connections.
NOTE: The PSPHD can only be powered by the included power cord. Power
cannot be supplied from network devices that are connected to the mini-terminal
block connectors.
NOTE: A USB port is concealed behind the label cover on the front panel. The USB
port is used to connect with a PC and provide a console connection to the PSPHD. A
microphone jack is also concealed behind the front panel's label cover. This jack is
used to connect the microphone that is included with the available Crestron
Professional Surround Sound Tuning Kit (sold separately). For more information,
refer to the latest version of the Crestron Professional Surround Sound Tuning Kit
Operations Guide (Doc. 6565).
Crestron PSPHD
Operations Guide – DOC. 6837C