Crestron TPS-IMC-BV Operation Manual page 7

Crestron TPS-IMC-BV
Operations Guide - DOC. 5921
Power Pack Specifications
CRESTRON POWER PACK
PW-2420RU
Power Pack Output Connector Polarity
NET – This four-pin connector is used to connect to other four-wire
devices in the Cresnet system. If making network connections to
control system or Cresnet peripherals, refer to "Network Wiring" on
page 5.
NET/VIDEO – This 10-position RJ45 mates with the TPS-5000 or
TPS-6000 touchpanel and has a dual purpose. Refer to the descriptions
and pinout table that follow this paragraph. A Triamese cable (15884)
is supplied with the TPS-XVGA-BV.
1. This port provides network connection to the touchpanel.
2. This port also makes available composite and S-video input for TV
video card (with the purchase and installation of the TPS-VID). Consult
the latest revision of the TPS-VID Operations & Installation Guide
(Doc. 5869) for details.
NET/VIDEO Pinouts
PIN # DESIGNATION
1
+24V
2
GND
3
C+
4
C-
5
Y
6
Z
7
Y+
8
Y-
9
GND
10
+24V
RGB – This 10-pin RJ45 port connects to the panel and is made active
with the purchase and installation of the TPS-XVGA-BV, RGB
Computer Interface Card. Consult the latest revision of the
TPS-XVGA-BV Operations & Installation Guide (Doc. 5920) for
details. A Triamese cable (15884) is supplied with the
TPS-XVGA-BV. Description of the pinouts is shown in the table after
this paragraph.
Interface Module
OUTPUT SPECS
24VDC 2A, regulated
DESCRIPTION
Power (Network)
Ground (Network)
Chrominance (Positive)
Chrominance (Negative)
Data (Network)
Data (Network)
Luminance (Positive)/Composite
Luminance (Negative)/Composite
Ground (Network)
Power (Network)
Interface Module: TPS-IMC-BV 3