Crestron Isys TPS-4000 Operation Manual page 29

®
Crestron Isys TPS-4000
Operations Guide - DOC. 6268
3. There are three system-wide join numbers that the designer can define.
The first, sound playing from panel, differs from the other two in that it
is triggered from the panel.
a. Sound Playing from Panel – The signal for this join number goes
high when the WAV file plays.
b. Mute Sounds – All WAV files (except the keyclick) in the project
are muted when this join number goes high.
c. Mute Key Click – The keyclick sound is muted when this join
number goes high.
Using Sound Manager
Sound Manager is broken into two distinct components. The Project Audio Joins
component, shown below, permits the designer to assign the three system-wide join
numbers described in the previous section. The three system joins can be assigned
automatically with the Auto button or by scrolling down to the desired number.
Project Audio Joins Component
The Sound List component, shown below, permits the designer to attach WAV files
to the touchpanel project. Complete the following steps to attach (add) a WAV file.
Sound List Component
1. Use the Browse button to locate the desired WAV files. It should
appear in the field adjacent to the Browse button.
2. If necessary, select the Play button to verify that the file in the browse
field is the desired file.
3. Select the Add button to transfer the WAV file to the Sound List table
located below the browse field. The audio parameters of the file also
appear to the right of the table.
4. Repeat steps 1 through 3 for each desired WAV file.
NOTE: To remove a WAV file from the Sound List table, highlight the file and
click on the Remove button.
10.4 Inch Tilt Touchpanel: Crestron Isys
10.4 Inch Tilt Touchpanel
®
TPS-4000 • 25