Crestron Isys TPS-4000 Operation Manual page 19

®
Crestron Isys TPS-4000
Operations Guide - DOC. 6268
AUDIO Pinouts
TYPE
8
1
Top
Front
1 8
To determine the location of pin 1, hold the supplied cable so that the end of the
8-pin RJ45 connector is facing away from you, with the clip side down and the
copper side up. The copper contact on the far left is pin 1.
NOTE: When connecting the touchpanel to the interface module, do not confuse the
8-pin audio cable with the 10-pin net/video cable.
RS-232
This 6-pin RJ-11 connector mates with a 9-pin serial port of a PC. The connecting
cable is not supplied. Use this port to establish a direct connection between the
touchpanel and a PC without a control system or network connection. Once the
direct connection is established, touchpanel files and firmware updates can be
uploaded to the touchpanel. Additionally, the touchpanel's diagnostic tools can be
accessed over the direct connection. In the event that modular cables or an RJ-11 to
DB9F adapter is not available, the following table and diagram provide information
so that the cable can be fabricated on site. Refer to "RS-232 Menu" on page 13 for
proper RS-232 port configuration settings.
RS-232 Pinouts
PIN # DESCRIPTION
1 CTS
2 GND
3 RXD
4 TXD
5 RTS
6 N/C (Not connected)
PC to TPS-4000 Cable Specifications (Crestron Cable Number STCP-502PC)
10.4 Inch Tilt Touchpanel: Crestron Isys
10.4 Inch Tilt Touchpanel
PIN DESIGNATION
1 L+
2 L-
3 GND/Shield Audio Input Ground/Shield
4 R+
5 R-
6 GND/Shield Mic Output Ground/Shield
7 M+
8 M-
1 6
Top
Front
6
1
DESCRIPTION
Left Input (Positive)
Left Input (Negative)
Right Input (Positive)
Right Input (Negative)
Mic Output (Positive)
Mic Output (Negative)
®
TPS-4000 • 15