Uploading A Vt Pro-E Project - Crestron TPS-1700 Operation Manual

®
Isys Wired 5.7 Inch Tabletop Touchpanel
The TPS-1700 touchpanel
source file has the extension
.vtp. A compiled VT Pro-e file
has the extension .vtz.
®
22 • Isys
Wired 5.7 Inch Tabletop Touchpanel: TPS-1700

Uploading a VT Pro-e Project

The VT Pro-e file can be uploaded to the touchpanel using VT Pro-e or via the
Crestron Viewport.
Upload via VT Pro-e
1. Start VT Pro-e.
2. Select File | Open | Project to view the "Open" window, navigate to
the VT Pro-e file (.vtp), and click Open.
3. Select File | Upload Project.
Upload via Crestron Viewport
1. Verify that the procedure for "Communication Settings" that begins on
page 18 has been performed.
2. As shown after this step, select File Transfer | Send Touchpanel
(alternatively, press Alt+T) from the Viewport menu.
File Transfer | Send Touchpanel Command
3. As shown after this step, select the Net ID of the TPS-1700 touchpanel
and then click OK. The "Touch Panel Transfer" window appears (refer
to graphic on the next page).
"Select Network ID" Window
NOTE: When transferring any Cresnet file (touchpanel project/firmware), lower the
port speed baud rate to 38400 to match the Cresnet bus speed.
Crestron TPS-1700
Operations Guide - DOC. 6223A