Unit-Initiated Messages - Extron electronics PowerCage FOX 4G Tx DVI User Manual

Unit-initiated Messages

When a local event, such as an equipment power-up, occurs, the unit responds by sending a
message to the host. The unit-initiated messages are listed below:
(c) Copyright 2010, Extron Electronics PowerCage FOX 4G
Tx VGA, Vx.xx, 70-699-xx ]]
- or -
(c) Copyright 2010, Extron Electronics PowerCage FOX 4G
Rx VGA, Vx.xx, 70-699-xx ]]
- or -
(c) Copyright 2010, Extron Electronics PowerCage FOX 4G Tx
DVI, Vx.xx, 70-700-xx ]]
- or -
(c) Copyright 2010, Extron Electronics PowerCage FOX 4G Rx
DVI, Vx.xx, 70-700-xx ]]
The connected unit issues the appropriate copyright message (above) when it first powers
on. Vx.xx is the firmware version number; 70-xxx-xx is the connected unit's part number.
Reconfig ]
The unit sends the Reconfig message whenever the video input signal to the transmitter is
changed.
1Lnk Y1( •2Lnk
The unit sends the status message whenever a change in the fiber link and video and audio
connection occurs.
Dip
Y$Y$
]
The unit sends the DIP switch position message whenever a change in the receiver's DIP
switch settings occurs.
NOTES: • This unit-initiated message occurs only when the connected receiver is a
Y1( •RGB Y1( •Aud Y1(
]
FOX 500 or FOXBOX unit.
• Only DIP switch 1 (the first Y$ ) has any effect on the system operation. When
the switch is on (up), the receiver is in daisy chain mode.
PowerCage FOX 4G DVI and PowerCage FOX 4G VGA • Remote Control 18