Installing a Board in the Enclosure
Up to 16 single slot or 8 dual slot input/output boards can be inserted into the PowerCage
enclosure. The PowerCage 4G transmitters and receivers are all dual slot boards.
NOTE:
1.
2.
3.
4.
5.
The boards are hot-swappable, and can be installed or removed without
disconnecting power to the PowerCage enclosure.
Use ESD precautions when installing a board to avoid damaging the board. Keep
the board in the anti-static bag until needed. Use proper grounding techniques
during installation.
Ensure power is removed from the PowerCage enclosure.
Position the board in the slot so that the power and communication ports on the
front end of the board are aligned with the matching ports inside of the board cage
(figure 27).
Figure 27.
Inserting Boards into the PowerCage 1600 Enclosure
Carefully slide the board into the slot and push the board firmly into place.
Tighten the 2 screws to secure the board into place.
Repeat steps 2 to 4 for all boards needing installation.
NOTE:
Ensure the boards are flush with the rear of the enclosure and the screws
tightened securely before applying power.
PowerCage FOX 4G DVI and PowerCage FOX 4G VGA • Reference Information
16 available single board slots or
8 double board slots
ge
w er
Ca
R AV
Po
M TP
Power
e
C ag
D I
w er
-S
H D
Po
X 3G
FO
e
Supply
C ag
w er
A V
R x
Po
X 2G
FO
e
C ag
R G
B
w er
Po
R X
X 4G
FO
z
/6 0H
50
0V
M A
X.
0- 24
10
5A
e
C ag
B
w er
R G
R X
Po
X 4G
FO
Board Retainer
Screws (2 per card)
40